Subaru Crosstrek Service Manual: Installation
SEAT BELT SYSTEM > Rear Seat Belt
INSTALLATION
1. SEAT BELT OUTER - REAR RH & LH
1. Before installation, perform a unit inspection of retractor. Rear Seat Belt > INSPECTION">
2. Install the seat belt outer - rear.
CAUTION:
• During installation, make sure that the seat belts are not twisted.
• After installation, make sure that the seat belts are smoothly extended and wound.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
3. Install the trim panel - rear quarter trim UPR.
4. Install the remaining parts in the reverse order of removal.
5. After installation, check the following points.
• The seat belt is not twisted.
• The seat belt can be pulled out and retracted smoothly.
2. SEAT BELT - REAR SHOULDER CTR
1. Install the seat belt - rear shoulder CTR.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
2. Install the remaining parts in the reverse order of removal.
3. After installation, check the following points.
• The seat belt is not twisted.
• The seat belt can be pulled out and retracted smoothly.
3. SEAT BELT - CTR RH AND LH
1. Install the seat belt - CTR RH/LH.
Tightening torque:
Rear seat belt: General Description > COMPONENT">
2. Install the rear seat cushion.
3. Install the remaining parts in the reverse order of removal.
4. After installation, check the following points.
• The seat belt is not twisted.
• Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.
Removal
SEAT BELT SYSTEM > Rear Seat BeltREMOVAL1. SEAT BELT OUTER - REAR RH & LHCAUTION:• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be carefu ...
Other materials:
Harness components location Location
WIRING SYSTEM > Harness Components LocationLOCATION(1)Front wiring harness(7)Rear wiring harness RH(12)Front door cord LH(2)Engine wiring harness(8)Rear wiring harness LH(13)Transmission cord(3)Bulkhead wiring harness(9)Roof cord(14)Generator cord(4)Instrument panel wiring harness(10)Rear gate co ...
Removal
EXHAUST(H4DO) > Front Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL"> ...
Dtc p013f o2 sensor delayed response - lean to rich bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013F O2 SENSOR DELAYED RESPONSE - LEAN TO RICH BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESP ...
