Subaru Crosstrek Service Manual: Clear memory mode Operation
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Tire Pressure Monitor» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Basic diagnostic procedure Procedure
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:Before removal or installation, be sure to remove any foreign matter (dust, moisture, oil, etc.) from the ...
Display transmitter (id) Operation
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Display Transmitter (ID)OPERATIONFor detailed operation procedures, refer to Read Current Data. Read Current Data"> ...
Other materials:
Dtc b2a01 tel1 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A01 TEL1 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the followings continues for 5 seconds or more.• TEL1 impedance is more than 1 M?. (Deta ...
Tilting moonroof
Raise
Lower
The tilting function is activated only when
the moonroof is fully closed.
To raise:
Press the rear side of the "UP/DOWN"
switch momentarily. The moonroof raises
completely.
To lower:
Press and hold the front side of the "UP/
DOWN" switch until the preferred positi ...
Removal
SECURITY AND LOCKS > Keyless BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.4. Remove the keyless buzzer.(1) Disconnect the connector.(2) Remove the clip and d ...
