
The tilting function is activated only when the moonroof is fully closed.
To raise: Press the rear side of the "UP/DOWN" switch momentarily. The moonroof raises completely.
To lower: Press and hold the front side of the "UP/ DOWN" switch until the preferred position has reached.
Release the switch after the moonroof has been raised or has been lowered completely.
Pressing the switch continuously may cause damage to the moonroof.
Sliding moonroofInspection
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemINSPECTIONSymptomsRepair orderWiper and washers do not operate.(1) Wiper fuse (F/B No. 14, 15)(2) Combination switch(3) Motor assembly - wiper(4) Wiring harnessWipers do not operate in LO or HI.(1) Combination switch(2) Motor assembly - wiper(3) W ...
Dtc p2135 throttle/pedal position sensor/switch "a"/"b" voltage correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2135 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A"/"B" VOLTAGE CORRELATIONDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving pe ...
CHECK ENGINE warning light/Malfunction indicator light
CAUTION
If the CHECK ENGINE warning light in your Subaru Ascent turns on while driving,
it is essential to have the vehicle inspected and repaired by an authorized SUBARU
dealer as soon as possible. Continuing to operate the Subaru Ascent without addressing
potential emission control system i ...