Subaru Crosstrek Service Manual: Installation

CAUTION:

• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL FOR IMMOBILIZER”.

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Tightening torque:

Security control module: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Security control module

Removal

Other materials:

Basic information before use
WARNING When the vehicle is stopped with the engine running, always apply the parking brake for safety. Failure to do so may result in loss of control of your vehicle and cause an accident or serious injury. CAUTION To prevent damaging the screen, touch the screen keys with your finge ...

Reverse Automatic Braking (RAB) system ON/OFF setting
In the Subaru Ascent, when the select lever is moved into the "R" (Reverse) position, you gain access to customizable settings for the Reverse Automatic Braking (RAB) system directly through the center information display. This allows the driver to conveniently enable or disable key ...

Procedure
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Preparation for OverhaulPROCEDURE1. Clean the transmission exterior.2. Remove the torque converter assembly. Torque Converter Assembly">3. Attach the ST on the transmission.ST 18632AA000STAND ASSY4. Remove the transmission case cover on the ...