Subaru Crosstrek Service Manual: Procedure

1. Clean the transmission exterior.

2. Remove the torque converter assembly. Torque Converter Assembly">

3. Attach the ST on the transmission.

4. Remove the transmission case cover on the transmission upper side.

NOTE:

After the transmission case cover (large) is installed, insert the transmission case cover (small) between the transmission case cover (large) and the transmission to install.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

5. Place the transmission assembly on end.

6. When completely overhauling the transmission, refill approx. 10 L (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug. Finally, install the transmission case cover.

CAUTION:

Always use specified CVTF. Using other fluid will cause malfunction. General Description > SPECIFICATION">

Use a new gasket.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Preparation for overhaul

General description

Other materials:

Steering responsive fog lights warning indicator/ Steering responsive fog lights OFF indicator (models with EyeSight system)
NOTE For details about the steering responsive fog lights system, refer to "Steering responsive fog lights system (models with EyeSight system)" Steering responsive fog lights warning indicator This indicator appears when the steering responsive fog lights system malfunctions. When this ...

Profiles
This system supports the following services. NOTE If your cell phone does not support HFP, registering the Bluetooth phone or using OPP, PBAP, or SPP profiles individually will not be possible. If the connected Bluetooth device version is older than recommended or incompatible, the ...

Removal
REAR SUSPENSION > Rear Shock AbsorberREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the sensor assembly - headlight beam leveler. (Model with auto headlight beam leveler, left side only)CAUTION ...