TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Tire Pressure Monitor» and then select «Enter».
5. On «Select Function» display, select «DTC».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC). List of Diagnostic Trouble Code (DTC)">
• All DTCs detected will be displayed.
• If a particular DTC is not properly stored in memory (due to a voltage drop of the TPMS & keyless entry CM or TPMS CM power supply, etc.) when a problem occurs, a DTC suffixed with a question mark appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
• When DTC is not displayed, check the indicator circuit and communication circuit. Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern">
List of diagnostic trouble code (dtc) List
Register transmitter (id) OperationInspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSPECTIONDisassembled parts should be washed with cleaning solvent first, then inspected carefully.1. BearingReplace the bearings in the following cases.• When the bearing balls, outer races and inner races are broken or rusty. ...
Dtc p014c a/f / o2 sensor slow response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P014C A/F / O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perfor ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearINSPECTION1. Ball bearingReplace the bearings in the following cases.• In case of broken or rusty bearings• In case of worn or damaged bearings• When the bearings fail to turn smoothly or emit noise in rotation after ...