Subaru Crosstrek Service Manual: Clear memory mode Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Air Conditioner» and select «Enter».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Basic diagnostic procedure Procedure

Diagnostic procedure for subaru select monitor communication Communication for initializing impossible

Other materials:

Caution
IGNITION(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cov ...

Tire care - maintenance and safety practices
Check on a daily basis that the tires are free from serious damage, nails, and stones. At the same time, check the tires for abnormal wear Inspect the tire tread regularly and replace the tires before their tread wear indicators become visible. When a tire's tread wear indicator b ...

Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsS ...