Subaru Crosstrek Service Manual: Adjustment
DIFFERENTIALS > Rear Differential (VA-type)
ADJUSTMENT
1. SIDE GEAR BACKLASH
Adjust the side gear backlash. Rear Differential (VA-type) > ASSEMBLY">
2. HYPOID DRIVEN GEAR BACKLASH
Adjust hypoid driven gear backlash. Rear Differential (VA-type) > ASSEMBLY">
3. TOOTH CONTACT BETWEEN HYPOID DRIVEN GEAR AND DRIVE PINION
Adjust the tooth contact between hypoid driven gear and drive pinion gear. Rear Differential (VA-type) > ASSEMBLY">
Assembly
DIFFERENTIALS > Rear Differential (VA-type)ASSEMBLYNOTE:• Assemble in the reverse order of disassembly.• Check and adjust each part during assembly.• Keep the shims and washers in ...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
Rear center seatbelt
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can increase the risk or
severity of injury in an accident.
When fastening the belt after it is
pulled out from the retractor, ...
Selecting audible signal operation (models without "keyless access with
push-button start system")
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the drive ...
