Subaru Crosstrek Owners Manual: License plate light
1. The license plate light must be pushed inwards, then pulled out to be removed.
2. Turn the bulb socket counterclockwise and pull out the socket.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the bulb socket and the license plate light cover.
Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
11-38
sembly rearward and remov ...
Map light
Type A
1. Remove the lens by prying the edge of
the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at
its ends are aligned vertically. Pull the bulb
straight down ...
Other materials:
Dtc p0890 tcm power relay sense circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0890 TCM POWER RELAY SENSE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed.CAUTION:• After diagnosis, perform Clear Memory Mo ...
Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main shaft spline• Contact surface of rele ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Converter CaseASSEMBLY1. Install the oil drain plug.Tightening torque:70 N·m (7.1 kgf-m, 51.6 ft-lb)2. Install the overflow drain plug.NOTE:Overflow plug of differential gear oil is temporarily attached.3. Install all plugs.NOTE:Use new O-rings.T ...
