Subaru Crosstrek Owners Manual: Replacing bulbs
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.
CAUTION
- Replace any bulb only with a new
bulb of the specified wattage.
Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to "Bulb chart" F12-13.
- Do not touch the glass portion of
the light bulb with bare hands.
When holding the glass portion is unavoidable, hold it using a clean dry cloth to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
- Headlights (models with HID headlights)
- Headlights (models without HID headlights)
- Rear combination lights
- License plate light
- Map light
- Dome light and cargo area light
Installation of accessories
Always consult your SUBARU dealer
before installing fog lights or any other
electrical equipment in your vehicle. Such
accessories may cause the electronic
system to malfunction if they are incorr ...
Headlights (models with HID headlights)
WARNING
High-intensity-discharge (HID) bulbs
are used for the low beams of the
headlights. These HID bulbs use an
extremely high voltage. To avoid the
risk of an electric shock that could
result ...
Other materials:
Caution
CONTROL SYSTEMS > General DescriptionCAUTION• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled ...
Note
POWER ASSISTED SYSTEM (POWER STEERING) > Power Steering SystemNOTEFor procedure of each component in the power steering system, refer to the respective section.• Steering wheel: Steering Wheel">• Universal joint assembly - steering: Universal Joint">• Steering ...
Basic diagnostic procedure Procedure
BODY CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.• Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and ...
