Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)
OPERATION
Read out DTCs stored in the airbag system and the occupant detection system.
1. AIRBAG SYSTEM
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Airbag» and select «Enter».
5. On «Airbag» display, select «DTC».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• For details concerning DTC, refer to List of Diagnostic Trouble Code (DTC) in AIRBAG SYSTEM. List of Diagnostic Trouble Code (DTC)">
2. OCCUPANT DETECTION SYSTEM
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Occupant Detection» and then select «Enter».
5. On «Occupant Detection» display, select «DTC».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">
Read current data Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Read Current DataOPERATIONCheck the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt bu ...
Parking brake
...
Other materials:
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeINSTALLATION1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4. ...
Dtc u0423 invalid data received from instrument panel cluster control module
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0423 INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULEThis is detected when CAN data from meter is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure &g ...
Rear windows side seating position
Head restraint
Release button
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks. Press and hold
the release button to lower t ...
