Subaru Crosstrek Service Manual: Adjustment

CAUTION:

• CVTF level changes along with CVTF temperature. When inspecting CVTF level, observe the specified CVTF temperature.

• Always use specified CVTF. Using other fluid will cause malfunction.

1. Idle the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor.

2. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling.

3. With the engine running, lift up the vehicle and remove the filler plug.

CAUTION:

Pay special attention to the following operations as the engine is at idle.

CVTF is at the specified level when it is up to the filler plug hole lower section.

4. When there is no CVTF leakage from the transmission, add the specified fluid up to the filler plug hole lower section.

Specified fluid:

General Description > SPECIFICATION">

Note that when CVTF is added up to the lower section of filler plug while the transmission is in cold condition, overfilling of CVTF occurs, causing the oil to spill out.

5. Install the filler plug.

NOTE:

Use a new gasket.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Cvtf

Condition check

Other materials:

Dtc b1011 battery control power supply
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1011 BATTERY CONTROL POWER SUPPLYDTC detecting condition:• Voltage failure caused by poor contact of battery power supply control circuit• Battery voltage of body integrated unit is not wit ...

Dtc p0776 pressure control solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0776 PRESSURE CONTROL SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine spe ...

Defrosting
Type A and B Select the "  " or "  " mode by turning the airflow mode selection dial to defrost or dehumidify the windshield and front door windows. Type C Select the "  " mode by pressing the defroster button, or select the " " mode by turning the airflow mode selec ...