Type A and B
Select the "
" or "
" mode by turning the
airflow mode selection dial to defrost or
dehumidify the windshield and front door
windows.
Type C
Select the "
" mode by pressing the
defroster button, or select the "
" mode
by turning the airflow mode selection dial
to defrost or dehumidify the windshield
and front door windows.
Type D
Select the "
" mode by pressing the
defroster button, or select the "
" mode
by pressing the airflow mode selection
button to defrost or dehumidify the windshield
and front door windows.
NOTE
When the "
" or "
"
mode is
selected, the air conditioner compressor
operates automatically regardless
of the position of the air conditioner
button to defrost the windshield more
quickly. However the indicator on the
air conditioner button will not illuminate.
At the same time, the air inlet selection is automatically set to the outside air mode.
For type A climate control system, in this state:
For type C and D climate control
system, after defrosting the windshield
by pressing the defroster button "
",
pressing the button again returns the
system to the setting that had been
selected before the defroster was activated.
Air inlet selectionContrast setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or ""
switch to
select the "Contrast" item. Then push the
button.
3. Select a contrast level by operating the
"
"
or "
" switch, and confirm the setting
b ...
Before starting out on a trip
Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also negate your
insurance coverage and/or may violate
the state road and traffic acts and regulation ...
Dtc u0327 software incompatibility with vehicle security control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0327 SOFTWARE INCOMPATIBILITY WITH VEHICLE SECURITY CONTROL MODULEDTC DETECTING CONDITION:No data is received from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operate proper ...