Subaru Crosstrek Owners Manual: Air inlet selection
Select the air inlet by pressing the air inlet selection button.
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selection button to the ON position for fast cooling with the air conditioner or when driving on a dusty road.
OFF position (outside air): Outside air is drawn into the passenger compartment.
Press the air inlet selection button to the OFF position when the interior has cooled to a comfortable temperature and the road is no longer dusty.
WARNING
Continued operation in the ON position may fog up the windows. Switch to the OFF position as soon as the outside conditions are no longer dusty.
NOTE
When the indicator light on the air inlet selection button is flashing at engine starting, a malfunction might be occurring in the electrical system.
Contact your SUBARU dealer for inspection.
The indicator light on the air inlet selection button may flash in the following cases. However, this does not indicate a malfunction.
- After the vehicle battery has been disconnected and reconnected.
- When the vehicle battery voltage is low.
Air conditioner control
The air conditioner operates only when
the engine is running.
Press the air conditioner button while the
fan is in operation to turn on the air
conditioner. When the air conditioner is
on, the ...
Defrosting
Type A and B
Select the "
" or "
" mode by turning the
airflow mode selection dial to defrost or
dehumidify the windshield and front door
windows.
Type C
Select the "
" m ...
Other materials:
Determining compatibility of tire and vehicle load capacities
The sum of four tires' maximum
load ratings must exceed the maximum
loaded vehicle weight
("GVWR"). In addition, sum of the
maximum load ratings of two front
tires and of two rear tires must
exceed each axle's maximum
loaded capacity ("GAWR"). Original
equipment tires are designed to
fulfil ...
Dtc b14e6 mode door actuator stepping motor circuit short-circuit
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E6 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT SHORT-CIRCUITDTC detecting condition:Mode door actuator stepping motor circuit is shorted.Trouble symptom:Vent does not change.Wiring diagram:Air condi ...
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the front wheels.3. Remove the front ABS wheel speed sensor.CAUTION:• Be careful not to damage the sensor.• Do not ap ...
