Subaru Crosstrek Owners Manual: Air conditioner control
The air conditioner operates only when the engine is running.
Press the air conditioner button while the fan is in operation to turn on the air conditioner. When the air conditioner is on, the "A/C" indicator light illuminates.
To turn off the air conditioner, press the button again.
NOTE
For efficient defogging or dehumidifying in cold weather, turn on the air conditioner. However, if the ambient temperature decreases to approximately 328F (08C), the air conditioner compressor will stop operating.
Temperature control
Type A
Turn the temperature control dial over a
range from the blue side (cool) to red side
(warm) to regulate the temperature of
airflow from the air outlets.
Type B, C and D
Turn the temperatu ...
Air inlet selection
Select the air inlet by pressing the air inlet
selection button.
ON position (recirculation): Interior air is
recirculated inside the vehicle. Press the
air inlet selection button to the ON posi ...
Other materials:
Removal
LIGHTING SYSTEM > Room LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - room.CAUTION:When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage.(1) Release the claws and remove the lens.(2) Remove the ...
Passive arming (models without "keyless access with push-button start
system")
Passive arming mode
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DOORS MUST BE
MANUALLY LOCKED.
Passive arming mode
When passive arming mode has been
programmed by ...
Dtc c1212 front right abs sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1212 FRONT RIGHT ABS SENSOR SIGNALNOTE:For the diagnostic procedure, refer to “DTC C1242 REAR LEFT ABS SENSOR SIGNAL”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) &g ...
