Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Warning and indicator lights

Mark Name
Seatbelt warning light
Front passenger's seatbelt warning light
SRS airbag system warning light
Front passenger's frontal airbag ON indicator
Front passenger's frontal airbag OFF indicator
CHECK ENGINE warning light/Malfunction indicator light
Coolant temperature low indicator light/ Coolant temperature high warning light
Charge warning light
Oil pressure warning light
Engine oil level warning light
AT OIL TEMP warning light (CVT models)
ABS warning light
Brake system warning light
Door open warning light
AWD warning light (CVT models)
Power steering warning light
Hill start assist warning light/Hill start assist OFF indicator light
Vehicle Dynamics Control warning light/ Vehicle Dynamics Control operation indicator light
Vehicle Dynamics Control OFF indicator light
Turn signal indicator lights
High beam indicator light
Automatic headlight beam leveler warning light (if equipped)
Front fog light indicator light
Access key warning indicator (if equipped)
Security indicator light
Headlight indicator light
Cruise control indicator light (if equipped)
Cruise control set indicator light (if equipped)
Low fuel warning light
Low tire pressure warning light (U.S.-spec. models)
Windshield washer fluid warning light
Steering responsive fog lights warning indicator/ Steering responsive fog lights OFF indicator (models with EyeSight system)
BSD/RCTA warning indicator (if equipped)
BSD/RCTA OFF indicator (if equipped)
Except U.S.-spec. models (type B)
The illustration above is a typical example. For some models, the combination meter may be slightly different than that shown in the illustration. Tachometer Multi information display F ...

Function settings
A SUBARU dealer can change the settings of the functions shown in the following table to meet your personal requirements. Contact the nearest SUBARU dealer for details. If your vehicle is equipped ...

Other materials:

Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveINSTALLATIONCAUTION:Replace the O-rings with new parts, and then apply compressor oil.1. Install each part in the reverse order of removal.Tightening torque:Heater and cooling unit: General Description > COMPONENT">Air conditio ...

Removal
SECURITY AND LOCKS > Body Integrated UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait ...

Removal
SECURITY AND LOCKS > Starter Relay (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from bat ...

© 2016-2024 Copyright www.sucross.com