Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Condition check

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF

CONDITION CHECK

NOTE:

When replacing CVTF, determine the condition inside the transmission body by inspecting the drained CVTF.

Fluid condition

Trouble and possible cause

Corrective action

Metal particles.

Excessive wear of the internal of the transmission body.

Replace CVTF and check if CVT operates correctly.

Thick and varnish-form fluid.

Burnt clutches

Replace CVTF and check the CVT body or vehicle for faulty.

Clouded CVTF or bubbles.

Water mixed in fluid.

Replace CVTF and check the water entering point.

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTFADJUSTMENTCAUTION:• CVTF level changes along with CVTF temperature. When inspecting CVTF level, observe the specified CVTF temperature.• ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTFINSPECTIONCheck for leakage of CVTF from transmission. ...

Other materials:

Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Manifold Absolute Pressure SensorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from intake manifold. ...

Dtc p0453 evap system (cpc) pressure sensor/switch circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0453 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mod ...

© 2016-2023 Copyright www.sucross.com