Subaru Crosstrek Service Manual: General diagnostic table Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General Diagnostic Table
INSPECTION
Symptoms | Faulty parts | |
Tire pressure warning light illuminates. | Tire pressure is reduced. | |
• Improper tire pressure adjustment
• Punctured tire
Tire pressure warning light blinks 25 times and then illuminates.
Tire pressure monitoring system has malfunction.
• Air pressure sensor malfunction
• Air pressure sensor is out of battery.
• Defective TPMS & keyless entry CM or TPMS CM
• Defective vehicle harness
• Defective combination meter
Tire pressure is dropping but the warning light does not illuminate.
Tire pressure warning light does not illuminate.
• Air pressure sensor is faulty.
• Defective TPMS & keyless entry CM or TPMS CM
• Defective combination meter
Electrical component location Location
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)TPMS & keyless entry CM or TPMS CM(2)Tire pressure warning light(3)Snap-in type transmitter• Model ...
Inspection mode Procedure
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Inspection ModePROCEDUREReproduce the malfunction occurrence condition as much as possible. Drive the vehicle at 40 km/h (25 MPH) or faster for at le ...
Other materials:
Driver Monitoring System indicator/warning
Driver Monitoring System operation indicator light (green)
Driver Monitoring System OFF indicator light
Driver Monitoring System temporary stop indicator light
Driver Monitoring System warning light (yellow)
In the Subaru Ascent, the Driver Monitoring System status is clearly communi ...
Dtc p0708 transmission range sensor "a" circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0708 TRANSMISSION RANGE SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shift characteristics are erroneous.• The r ...
Installation
EXTERIOR/INTERIOR TRIM > Front GrilleINSTALLATIONCAUTION:• Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).• Before installing the bumper face, match the cla ...
