Subaru Crosstrek Service Manual: Removal
MECHANICAL(H4DO) > Engine Mounting
REMOVAL
1. Remove the front crossmember. Front Crossmember > REMOVAL">
2. Remove the engine mounting from the engine.
Inspection
MECHANICAL(H4DO) > Engine MountingINSPECTIONMake sure that there are no cracks or other damages. ...
Installation
MECHANICAL(H4DO) > Engine MountingINSTALLATIONInstall in the reverse order of removal.Tightening torque:35 N·m (3.6 kgf-m, 25.8 ft-lb) ...
Other materials:
Installation
EXTERIOR/INTERIOR TRIM > Front Under CoverINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).Install each part in the reverse order of removal.Tightenin ...
Dtc p014c a/f / o2 sensor slow response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P014C A/F / O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perfor ...
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyADJUSTMENT1. PROCEDURE IN REPLACEMENT OF PRIMARY AND SECONDARY PULLEY, OR IN REPLACEMENT OF PRIMARY PULLEY, SECONDARY PULLEY AND VARIATOR CHAIN1. Measure depth “Lp” from the ST upper face to the primary pul ...
