Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator Assembly
INSTALLATION
1. Before installation, check the following items.
• Rod is free from deformation.
• Grease is applied sufficiently to rod joints.
If grease is insufficient, add it as necessary before assembling the rod.
• If the lever is faulty, replace the front outer handle.
• If the rod is deformed, replace the latch & actuator assembly - front.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - front. Always replace with a new part.
Tightening torque:
Door lock assembly: General Description > COMPONENT">
Sash COMPL - lower: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Removal
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at ...
Other materials:
Dtc c0026 rear right abs sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0026 REAR RIGHT ABS SENSOR SIGNALNOTE:For the diagnostic procedure, refer to “DTC C0028 REAR LEFT ABS SENSOR SIGNAL”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Dtc b16f2 front sub sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F2 FRONT SUB SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:Front sub sensor (RH) is misinstalled.CAUTION:Before performing diagnosis, refer to “CAUTION&rdqu ...
Dtc p0801 reverse inhibit control circuit/open
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0801 REVERSE INHIBIT CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Immediately at fault recognitionNOTE:For diagnostic procedures, refer to “BODY CONTROL SYSTEM (DIAGNOSTICS)”. ...
