Subaru Crosstrek Service Manual: Dtc p0801 reverse inhibit control circuit/open
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0801 REVERSE INHIBIT CONTROL CIRCUIT/OPEN
DTC DETECTING CONDITION:
Immediately at fault recognition
NOTE:
For diagnostic procedures, refer to “BODY CONTROL SYSTEM (DIAGNOSTICS)”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1016 SHIFT LOCK CIRCUIT">
1. OUTLINE OF DIAGNOSIS
• Detect the malfunction of shift lock solenoid or circuit.
• Judge as NG if abnormal signal from the integrated unit is received, when bus off is not detected and there is no trouble in CAN between the integrated unit.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
None |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
Shift lock solenoid system circuit abnormal (received from BIU) | ON |
Time Needed for Diagnosis: 1 second
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc p0776 pressure control solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0776 PRESSURE CONTROL SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condit ...
Dtc p0841 transmission fluid pressure sensor/switch "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0841 TRANSMISSION FLUID PRESSURE SENSOR/SWITCH "A" CIRCUIT RANGE/PERFORMANCE ...
Other materials:
Malfunction indicator light does not go off
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT GO OFFTROUBLE SYMPTOM:Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.STEPCHECKYESNO1.CHECK DTC.Is DTC of eng ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...
Installation
AIRBAG SYSTEM > Curtain Airbag SensorINSTALLATIONCAUTION:• Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.• When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.1. Before installation, ...
