Subaru Crosstrek Service Manual: Installation

CAUTION:

• Do not reuse the bolt and nut.

Always replace with the specified new bolts and nuts.

• When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Curtain airbag sensor or connector is damaged.

• Curtain airbag module has been activated.

2. Install each part in the reverse order of removal.

Tightening torque:

Curtain airbag sensor: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Curtain airbag sensor

Removal

Other materials:

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorREMOVAL1. INTAKE SIDE1. Disconnect the ground cable from battery.2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the camshaft position sensor, and remove the cam ...

Dtc p0400 egr "a" flow
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0400 EGR "A" FLOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Movement performance problem when engine is low speed• Improper i ...

Dtc u0101 lost communication with tcm
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDTC detecting condition:No data is received from TCM.Trouble symptom:Cooperation control with transmission is not performed.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC P ...