Subaru Crosstrek Service Manual: Abs warning light does not go off

Detecting condition:

• Defective combination meter

• Defective CAN communication

1.READ DTC.

Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Warning Light Illumination Pattern > ABS WARNING LIGHT DOES NOT GO OFF">Go to Step 2.

2.CHECK VDCCM.

Display the current data of VDCCM using Subaru Select Monitor.

Is the «ABS Warning Lamp» ON?

Warning Light Illumination Pattern > ABS WARNING LIGHT DOES NOT GO OFF">Go to Step 3.

Warning Light Illumination Pattern > ABS WARNING LIGHT DOES NOT GO OFF">Go to Step 4.

3.READ DTC.

Read the DTC after driving the vehicle at 40 km/h (25 MPH) or more.

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Warning Light Illumination Pattern > ABS WARNING LIGHT DOES NOT GO OFF">Go to Step 4.

4.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault in LAN system?

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">

Warning Light Illumination Pattern > ABS WARNING LIGHT DOES NOT GO OFF">Go to Step 5.

5.CHECK COMBINATION METER.

Check the combination meter. Combination Meter System > OPERATION">

Is the check result OK?

• Models without EyeSight
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
• Models with EyeSight
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Replace the combination meter. Combination Meter">

Ebd warning light, abs warning, vdc off indicator light, vdc warning light and vdc indicator light do not come on

Vdc warning light and vdc indicator light do not go off

Other materials:

Dtc p0024 "b" camshaft position - timing over-advanced or system performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0024 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...

Keyless buzzer volume setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the "  " or " " switch to select the "Keyless Buzzer Volume" item. Then push the  button. 3. Select a volume level by operating the "  " or "  " switch, and confirm the set ...

Malfunction indicator light does not blink
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT BLINKDIAGNOSIS:• The malfunction indicator light circuit is open or shorted.• The delivery (test) mode fuse circuit is open.TROUBLE SYMPTOM:Malfunction indicator light does not blink during In ...