VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination Pattern
VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF
Detecting condition:
• Defective combination meter
• Defective engine
• Defective CAN communication
Trouble symptom:
VDC warning light and VDC indicator light do not go off when starting the engine.
| STEP | CHECK | YES | NO |
1.READ DTC.
Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF">Go to Step 2.
2.CHECK VDCCM.
Display the current data of VDCCM using Subaru Select Monitor.
Is the «VDC Warning Lamp» ON?
Warning Light Illumination Pattern > VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF">Go to Step 3.
Warning Light Illumination Pattern > VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF">Go to Step 4.
3.READ DTC.
Read the DTC after driving the vehicle at 40 km/h (25 MPH) or more.
Is DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF">Go to Step 4.
4.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. Basic Diagnostic Procedure">
Is there any fault in LAN system?
Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF">Go to Step 5.
5.CHECK COMBINATION METER.
Check the combination meter. Combination Meter System > OPERATION">
Is the check result OK?
• Models without EyeSight
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
• Models with EyeSight
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
Replace the combination meter. Combination Meter">
Abs warning light does not go off
Vdc off indicator light does not go offInstallation
MECHANICAL(H4DO) > Rocker CoverINSTALLATION1. ROCKER COVER RH1. Install the #1 spark plug pipe gasket and #3 spark plug pipe gasket to the #1 spark plug pipe and #3 spark plug pipe.NOTE:• Use a new #1 spark plug pipe gasket and #3 spark plug pipe gasket.• Apply a light coat of engine ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 14 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...
Installation
SECURITY AND LOCKS > Keyless Access CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FO ...