Subaru Crosstrek Service Manual: Installation

CAUTION:

• If the sealing cover - front door gets broken, replace it with a new part.

• Apply a uniform bead of butyl tape.

• Attach the sealing cover - front door, keeping it from becoming wrinkled.

• Breaks in the bead will allow water leakage and contamination.

1. Install the sealing cover - front door.

(1) Forcefully push the butyl tape portion to prevent any floating on surface.

(2) When replacing the sealing cover, use the butyl tape.

Preparation items:

Butyl tape: 3M Butyl Rubber 8626 or equivalent

2. Install each part in the reverse order of removal.

NOTE:

Before installation, check the following items.

• Rod of the latch and actuator assembly - front is free from deformation.

• Grease is applied sufficiently to the rod joints of the latch and actuator assembly - front.

• Cable of the latch and actuator assembly - front is free from deformation such as fray.

• Grease is applied sufficiently to the cable joints of the latch and actuator assembly - front.

Removal

General description

Other materials:

Note
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Control SystemNOTEFor operation procedures of each component of the sunroof control system, refer to the respective section.• Glass lid: Glass Lid">• Sunroof assembly: Sunroof Assembly">• Sunroof motor: Sunroof ...

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...

Specification
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlSPECIFICATION1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROLWhen the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.• When the speed of at least one wheel reaches ...