Subaru Crosstrek Owners Manual: Cruise control indicator light (if equipped)
This
light illuminates when the cruise
control main button is pressed to activate
the cruise control function. For details,
refer to "To set cruise control"
CAUTION
If the CHECK ENGINE warning light/ malfunction indicator light illuminates, the cruise control indicator light flashes at the same time. At this time, avoid driving at high speed and have your vehicle inspected at a SUBARU dealer as soon as possible.
Cruise control set indicator light (if equipped)
This
light illuminates when vehicle speed
has been set to use the cruise control
function. Refer to "To set cruise control"
Select lever/gear position indicator (CVT models)
Type A
Upshift indicator
Downshift indicator
Select lever/gear position indicator
Type B
Upshift indicator
Downshift indicator
Select lever/gear position indicator
This i ...
Automatic headlight beam leveler warning light (models with HID headlights)
This
light illuminates when the automatic
headlight beam leveler does not operate
normally.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turnin ...
Other materials:
Engine overheating
WARNING
Never remove the radiator cap of your Subaru Ascent until the engine has been
completely switched off and allowed to cool down fully. When the engine is hot,
the cooling system remains under high pressure.
Opening the cap prematurely may cause a sudden release of pressurized, boiling ...
Blind spot detection/rear cross traffic alert
Note
Blind Spot Detection/Rear Cross Traffic Alert > Blind Spot Detection/Rear Cross Traffic AlertNOTEFor procedure of each component in the Subaru Rear Vehicle Detection system, refer to the respective sections.• Radar sensor: Radar Sensor">• BSD/RCTA OFF switch: Switches ...
Assembly
CLUTCH SYSTEM > Clutch PedalASSEMBLY1. Install the stopper and pedal pad to the clutch pedal.2. Install the clutch switch to the pedal bracket.3. Clean the pedal bushing holes of the clutch pedal and the brake pedal, apply grease, and install the pedal bushings.4. Install the clutch pedal, brake ...
