Subaru Crosstrek Service Manual: Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Subaru Select Monitor
OPERATION
• For detailed operation procedures, refer to “Application help”.
• If the combination meter or MFD can not communicate with Subaru Select Monitor, perform the “Communication for Initializing Impossible”. Subaru Select Monitor > INSPECTION">
If the DTCs related to the LAN system are not displayed, perform the inspection by connecting the Subaru Select Monitor to another vehicle which is operating properly and by establishing the communication.
Inspection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLE (COMBINATION METER)Detecting condition:• Defective harness connector&bu ...
Other materials:
Removal
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Disconnect the connector (A).3. Remove the nut (B) securing accelerator pedal assembly, and remove the accelerator pedal assembly. ...
Dtc b2a0e mute line circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0E MUTE LINE CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the following conditions occurs continuously for five seconds or more after the ignition switch i ...
Removal
EXTERIOR/INTERIOR TRIM > Front GrilleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front. Front Bumper > REMOVAL">3. Remove the front grille assembly.(1) Remove the screws from the back side of the bumper face - front.(2) Release the cl ...
