Subaru Crosstrek Service Manual: Front door latch and door lock actuator assembly

Inspection

SECURITY AND LOCKS > Door Lock Control SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceThe door lock control system does not operate.1. Remove and visually inspect the following fuses. ...

Inspection

SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly ...

Other materials:

Dtc p2401 evap system leak detection pump control circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2401 EVAP SYSTEM LEAK DETECTION PUMP CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...

Inspection
SECURITY AND LOCKS > Rear Lock ButtonINSPECTION1. Using the Subaru Select Monitor, display «Rear gate/Trunk UNLOCK output» from «Data monitor».2. Check if the display changes when the rear lock button is operated.3. If the display is not correct as the result of inspection, refer to “Ge ...

Installation
MECHANICAL(H4DO) > Cam SprocketINSTALLATION1. CAM SPROCKET RH• Intake cam sprocket RH1. Install the intake cam sprocket RH by aligning the knock hole (A) of intake cam sprocket RH and the knock pin (B) of intake camshaft RH.NOTE:Before installation, check that there is no foreign matter on ...