Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Wiring diagram

OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O Signal

WIRING DIAGRAM

Refer to “Occupant Detection System” in the wiring diagram. Occupant Detection System > WIRING DIAGRAM">

Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONCAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame becaus ...

Diagnostic procedure with diagnostic trouble code (dtc)
...

Other materials:

Power supply circuit Wiring diagram
WIRING SYSTEM > Power Supply CircuitWIRING DIAGRAM1. WITHOUT PUSH BUTTON START• Engine room side• Passenger room sideNo.LoadMB-1VDC CMMB-2VDC CMMB-3Wiper relayMB-4Sub fan relayMB-5Mirror heater LHMirror heater RHRear defoggerA/C control panelMB-6Body integrated unitMB-7Main fan relay ...

Removal
ENTERTAINMENT > Front SpeakerREMOVAL1. TWEETER1. Disconnect the ground cable from battery. NOTE">2. Remove the speaker assembly - tweeter.(1) Release the clips and claws, then detach the grille speaker side.NOTE:Remove the grille speaker side by using a plastic remover.(2) Remove the scr ...

Disassembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the rear h ...

© 2016-2026 Copyright www.sucross.com