Subaru Crosstrek Service Manual: Pretensioner connector Procedure
SEAT BELT SYSTEM > Pretensioner Connector
PROCEDURE
For connectors of seat belt pretensioner, lap seat belt pretensioner and buckle switch RH, refer to “Airbag Connector” of “AIRBAG SYSTEM” section or “OCCUPANT DETECTION SYSTEM” section.
• Airbag system: Airbag Connector > PROCEDURE">
• Occupant detection system: Airbag Connector > PROCEDURE">
Inspection locations after a collision Inspection
SEAT BELT SYSTEM > Inspection Locations after a CollisionINSPECTIONRefer to “Inspection Locations after a Collision” of “AIRBAG SYSTEM” section. Inspection Locations after ...
Seats
...
Other materials:
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)REMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the instrument panel lower cover. Instrument Panel Lowe ...
Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEDTC detecting condition:Defective harness connectorTrouble symptom:Communication is impossible between the airbag control module and the Subaru Select Monitor.CAUTION:Before performing diagnos ...
Assembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingASSEMBLY1. Install the rear hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)(1)Rear hub unit bearing2. Using a press, press new hub bolts (b) until their seating surfaces contact the rear hub unit bearing (a).NOTE:Use the 12 ...
