Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: To help prevent corrosion

Wash the vehicle regularly to prevent corrosion of the body and suspension components. Also, wash the vehicle promptly after driving on any of the following surfaces.

After the winter has ended, it is recommended that the underbody be given a very thorough washing.

Before the beginning of winter, check the condition of underbody components, such as the exhaust system, fuel and brake lines, brake cables, suspension, steering system, floor pan, and fenders. If any of them are found to be rusted, they should be given an appropriate rust prevention treatment or should be replaced. Contact your SUBARU dealer to perform this kind of maintenance and treatment if you need assistance.

Repair chips and scratches in the paint as soon as you find them.

Check the interior of the vehicle for water and dirt accumulation under the floor mats because that could cause corrosion.

Occasionally check under the mats to make sure the area is dry.

Keep your garage dry. Do not park your vehicle in a damp, poorly ventilated garage. In such a garage, corrosion can be caused by dampness. If you wash the vehicle in the garage or put the vehicle into the garage when wet or covered with snow, that can cause dampness.

If your vehicle is operated in cold weather and/or in areas where road salts and other corrosive materials are used, the door hinges and locks, and hood latch should be inspected and lubricated periodically.

Most common causes of corrosion
The most common causes of corrosion are: The accumulation of moisture retaining dirt and debris in body panel sections, cavities, and other areas. Damage to paint and other protective coa ...

Cleaning the interior
Use a soft, damp cloth to clean the climate control panel, audio equipment, instrument panel, center console, combination meter panel, and switches. (Do not use organic solvents.) ...

Other materials:

Inspection
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING THE AIRBAG SYSTEM IS IMPOSSIBLEDETECTING CONDITION:Defective harness connectorTROUBLE SYMPTOM:Communication is impossible between the airbag control module and the Subaru Select Monitor.NOTE ...

Disassembly
SEATS > Rear SeatDISASSEMBLY1. Remove the rear seat. Rear Seat > REMOVAL">2. Remove the headrest assembly - rear backrest.3. Remove the armrest assembly - rear center. (model with armrest assembly - rear center)(1) Remove the cover - armrest by pulling it in the direction of the arrow ...

Removal
SECURITY AND LOCKS > Front Inner RemoteREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the screw, and remove the remote assembly - door.CAUTIO ...

© 2016-2026 Copyright www.sucross.com