WIPER AND WASHER SYSTEMS > Wiper and Washer System
INSPECTION
Symptoms | Repair order |
Wiper and washers do not operate. |
(1) Wiper fuse (F/B No. 14, 15)
(2) Combination switch
(3) Motor assembly - wiper
(4) Wiring harness
Wipers do not operate in LO or HI.
(1) Combination switch
(2) Motor assembly - wiper
(3) Wiring harness
Wipers do not operate in INT.
(1) Combination switch
(2) Motor assembly - wiper
(3) Wiring harness
Washer motor does not operate.
(1) Combination switch
(2) Motor pump assembly - washer
(3) Wiring harness
Wipers do not operate when washer switch is ON.
(1) Motor assembly - wiper
(2) Wiring harness
Washer fluid spray does not operate properly.
(1) Motor pump assembly - washer
(2) Hose assembly - washer
(3) Nozzle - washer
Wiper chatters or judders during operation.
(1) Oil film and dirt on the glass
(2) Arm assembly windshield wiper
(3) Motor assembly - wiper
Wiring diagramCaution
EXHAUST(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cove ...
Dtc b1408 meter non-volatile memory
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1408 METER NON-VOLATILE MEMORYDTC DETECTING CONDITION:Defective combination meterCAUTION:When the combination meter is replaced, registration of the immobilizer system is required. For details, refer to the &l ...
Alarm system setting
The Subaru Ascent allows you to customize the alarm system by switching between
activation and deactivation modes. This flexibility enables you to adapt the vehicle’s
security behavior to your specific needs.
To modify the Subaru Ascent alarm system settings, follow these steps carefully:
1. ...