Subaru Crosstrek Service Manual: Inspection locations after a collision Inspection
SEAT BELT SYSTEM > Inspection Locations after a Collision
INSPECTION
Refer to “Inspection Locations after a Collision” of “AIRBAG SYSTEM” section. Inspection Locations after a Collision">
Disposal of pretensioner Procedure
SEAT BELT SYSTEM > Disposal of PretensionerPROCEDUREWARNING:Make sure to follow the instructions below. Otherwise, personal injuries may occur.• Before discarding a pretensioner, always perfo ...
Pretensioner connector Procedure
SEAT BELT SYSTEM > Pretensioner ConnectorPROCEDUREFor connectors of seat belt pretensioner, lap seat belt pretensioner and buckle switch RH, refer to “Airbag Connector” of “AIRBAG ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...
Precautions against vehicle modification
Always consult your SUBARU dealer if
you want to install any accessory parts to
your vehicle.
CAUTION
Do not perform any of the following
modifications. Such modifications
can interfere with proper operation
of the seatbelt pretensioners.
Attachment of any equipment
(bush bar, winches, ...
Removal
EXTERIOR BODY PANELS > Front FenderREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front. Front Bumper > REMOVAL">3. Remove the light assembly - head. Headlight Assembly > REMOVAL">4. Remove the cover - front fender.(1) Remove ...
