Subaru Crosstrek Owners Manual: Headlight beam leveler (if equipped)
Automatic headlight beam leveler (models with HID headlights)
The HID headlights generate more light than conventional halogen headlights.
Therefore a driver of an oncoming vehicle may experience too much glare if your headlight beam height adjustment is high when the vehicle is carrying a heavy load.
The automatic headlight beam leveler adjusts the headlight beam height automatically and optimally according to the load being carried by the vehicle.
Illumination brightness control
The illumination brightness of the instrument
panel dims under the following
conditions.
when the light switch is in the "
" or
" " position
You can also adjust the illumination brigh ...
Fog light switch
Headlight switch
Fog light switch
The front fog lights will turn on when the
fog light switch is placed in the "
"
position while the headlights are in the
following condition.
...
Other materials:
Installation
EXTERIOR/INTERIOR TRIM > Front BumperINSTALLATION1. Install each part in the reverse order of removal.2. Secure the flange section of the bumper face - front to the bracket - front bumper side.CAUTION:• Install so that the front end of the under cover (b) comes inside the bumper face - fron ...
Safety precautions
WARNING
Bulbs may become very hot while
illuminated. Before replacing
bulbs, turn off the lights and wait
until the bulbs cool down. Otherwise,
there is a risk of sustaining
a burn injury.
For models with HID low beam
headlights, observe the following
precautions. Not doing so carries
the ...
Dtc p0747 pressure control solenoid "a" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0747 PRESSURE CONTROL SOLENOID "A" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor du ...
