Subaru Crosstrek Owners Manual: Illumination brightness control
The illumination brightness of the instrument panel dims under the following conditions.
when the light switch is in the "
" or
"
" position
You can also adjust the illumination brightness for better visibility in the following ways.
To brighten, turn the control dial upward.
To darken, turn the control dial downward
NOTE
- When the control dial is turned fully upward, the illumination brightness becomes the maximum and the automatic dimming function does not work at all.
- The brightness setting is not canceled even when the ignition switch is turned to the "LOCK"/"OFF" position.
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatica ...
Headlight beam leveler (if equipped)
Automatic headlight beam leveler (models with
HID headlights)
The HID headlights generate more light
than conventional halogen headlights.
Therefore a driver of an oncoming vehicle
may experien ...
Other materials:
Dtc p0951 auto shift manual control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:Manual mode can not be set.CAUTION:Use the check board whe ...
Dtc b2271 ign relay control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2271 IGN RELAY CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in IG1 and IG2 drive circuits in the keyless access CM.• When malfunction is de ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...
