
The front fog lights will turn on when the
fog light switch is placed in the "
"
position while the headlights are in the
following condition.
"
positionTo turn off the front fog lights, turn the
switch back down to the "
"
position.

Indicator light (type A)

Indicator light (type B)
The indicator light on the combination meter will illuminate when the front fog lights are illuminated.
Steering responsive fog lights system (models with EyeSight system)
The steering responsive fog lights system automatically turns the front fog light on and off based on the steering angle and vehicle speed when entering a curve or driving on curved roads. The system is intended to help prevent accidents by enabling better visibility of curves ahead and early recognition of any disabled vehicles or other obstacles.
The front fog light on the inside of a curve will turn on if all of the following conditions are met.
"
positionThe front fog lights on both sides will turn on as usual if all of the following conditions are met.
"
positionSteering responsive fog lights OFF switch

Steering responsive fog lights OFF switch
Press this switch to deactivate the steering responsive fog lights system. Press the switch again to activate the system.
Steering responsive fog lights OFF indicator

Steering responsive fog lights OFF indicator
This indicator appears when the steering responsive fog lights system is deactivated.
This indicator disappears when the system is activated.
Headlight beam leveler (if equipped)
Wiper and washerElectrical component location Location
IMMOBILIZER (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Security indicator light (LED bulb)(3)Data link connector(5)Transponder(2)Body integrated unit(4)Antenna(6)Security control module (for C5 model only) ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyASSEMBLY1. Install the reverse brake piston.NOTE:Apply CVTF to the sealing area of reverse brake piston.2. Install the return spring.3. Install the spring retainer.4. Compress the return spring using the ST to install the snap ring ...
Intake and exhaust valve Specification
MECHANICAL(H4DO) > Intake and Exhaust ValveSPECIFICATIONRefer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL"> Cylinder Head > INSTALLATION"> ...