Subaru Crosstrek Service Manual: Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering Wheel
INSPECTION
1. PADDLE SHIFT SWITCH
Check the resistance of paddle switch.
| STEP | CHECK | YES | NO |
1.SHIFT-UP SWITCH CONTINUITY CHECK.
1) Operate the + side of paddle shift assembly and hold it.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 4 — No. 3:
Is the resistance less than 10 ??
Steering Wheel > INSPECTION">Go to Step 2.
Replace the paddle shift assembly.
2.SHIFT-DOWN SWITCH CONTINUITY CHECK.
1) Operate the − side of paddle shift assembly and hold it.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 1 — No. 4:
Is the resistance less than 10 ??
Steering Wheel > INSPECTION">Go to Step 3.
Replace the paddle shift assembly.
3.CHECK SHIFT SWITCH INSULATION.
1) Do not operate the paddle shift assembly.
2) Measure the resistance between terminals of the paddle shift assembly connector.
Terminals
No. 4 — No. 3:
No. 1 — No. 4:
Is the resistance 1 M? or more?
Paddle shift assembly is normal.
Replace the paddle shift assembly.
Replace the paddle switch if the inspection result is not within the standard value.
2. SATELLITE SWITCH ASSEMBLY
• Audio (navigation) switch: Switches and Harness > INSPECTION">
• EyeSight steering switch Switches and Harness > INSPECTION">
• Cruise control command switch: Cruise Control Command Switch > INSPECTION">
3. MID SWITCH
Refer to “Steering Switch” of “INSTRUMENTATION/DRIVER INFO” section. Steering Switch > INSPECTION">
Disassembly
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelDISASSEMBLY1. CROSSTREK MODEL1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)2. Rel ...
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” ...
Other materials:
Dtc b1610 front sub sensor rh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1610 FRONT SUB SENSOR RH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front sub sensor (RH) is faulty.If DTC B1610 is displayed, the circuit within the front sub sensor (RH) is faulty ...
Note
LIGHTING SYSTEM > Headlight SystemNOTEFor operation procedures of each component of the headlight system, refer to the respective section.• Headlight Assembly: Headlight Assembly">• Headlight bulb: Headlight Bulb">• Combination switch (light): Combination Swit ...
Removal
MECHANICAL(H4DO) > Engine AssemblyREMOVAL1. Open the front hood, and make alignment marks (A) on both the front hood and the front hood striker by using a marker pen.2. Remove the front hood striker from the front hood.3. Change the front hood stay position from (A) to (B), and completely open th ...
