Subaru Crosstrek Service Manual: Removal

1. Disconnect the ground cable from battery. NOTE">

2. Remove the trim panel - rear gate UPR.

(1) Remove the claws on the trim edge.

(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.

3. Remove the roof spoiler assembly. (Model with roof spoiler) Roof Spoiler > REMOVAL">

4. Remove the light assembly - high-mounted.

(1) Remove the nut.

(2) Disconnect the connector and remove the light assembly - high-mounted.

5. Remove the nozzle - rear washer.

CAUTION:

Before removing, apply protective tape to the body panel and used tools not to damage the panel - rear gate.

(1) Push the claw using a flat tip screwdriver, etc.

(2) When the nozzle - rear washer lifts up, pull out the nozzle - rear washer using a clip remover, etc.

(3) Disconnect the hose - rear washer, and remove the nozzle - rear washer.

Inspection

Installation

Other materials:

Dtc b2786 steering lock cm communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2786 STEERING LOCK CM COMMUNICATIONDTC detecting condition:When communication between keyless access CM and steering lock CM is interrupted for a set amount of time.Trouble sym ...

Top display setting
1. Perform the preparation steps according to "Preparation for screen settings" 2. Operate the " " or " " switch to select the "Top Display" item. Then push the button. 3. Push the button once more. 4. Select an item by operating the "  " or "  " switc ...

Selecting audible signal operation (models without "keyless access with push-button start system")
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Perform the following steps to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the drive ...