Subaru Crosstrek Service Manual: Installation
WIPER AND WASHER SYSTEMS > Rear Washer
INSTALLATION
1. Install each part in the reverse order of removal.
Tightening torque:
Light assembly - high-mounted: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Roof spoiler assembly: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
2. Check the nozzle - rear washer position. Rear Washer > INSPECTION">
Removal
WIPER AND WASHER SYSTEMS > Rear WasherREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release t ...
Rear wiper arm
...
Other materials:
Automatic headlight beam leveler warning light (models with HID headlights)
This
light illuminates when the automatic
headlight beam leveler does not operate
normally.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turning the ignition switch to the "ON"
position, have your vehicle inspected at
your SUBARU dealer.
Fr ...
32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...
Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the h ...
