Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Door Switch
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the switch assembly - door.
(1) Remove the screws, and pull out the switch assembly - door toward you.
(2) Disconnect the connector and remove the switch assembly - door.
Inspection
LIGHTING SYSTEM > Door SwitchINSPECTION1. Check the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram1 — 3When door is ...
Installation
LIGHTING SYSTEM > Door SwitchINSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Dtc c0035 rr hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0035 RR HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...
Removal
LIGHTING SYSTEM > Luggage Room LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - luggage room.CAUTION:When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage.(1) Release the claws and remove the main ...
