Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Lighting system / Door switch / Inspection

LIGHTING SYSTEM > Door Switch

INSPECTION

1. Check the resistance between switch terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard	Connection diagram
1 — 3	When door is opened	Less than 1 ?

When door is closed

1 M? or more

2. Replace the switch assembly - door if the inspection result is not within the standard value.

Removal

LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door t ...

Other materials:

Dtc p0852 park/neutral switch input circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0852 PARK/NEUTRAL SWITCH INPUT CIRCUIT HIGH1. AT MODELDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing or replacing ...

Odometer
Type A Trip knob Type B Trip knob (U.S.-spec. models) Trip knob (except U.S.-spec. models) This meter displays the odometer when the ignition switch is in the "ON" position. The odometer shows the total distance that the vehicle has been driven. If you press the trip knob ...

Anti-entrapment function
CAUTION Never attempt to test this function using fingers, hands or other parts of your body. The anti-entrapment function may not operate properly if some object gets trapped just before the window fully closes. NOTE If a window detects an impact similar to that caused by t ...