Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting System
INSTALLATION
1. PITCHING STOPPER
1. Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
2. Install the air intake boot. Air Intake Boot > INSTALLATION">
3. Connect the battery ground terminal.
2. CROSSMEMBER AND CUSHION RUBBER
1. Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
2. Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B).
Tightening torque:
Bolt (A)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
3. Install the front crossmember and rear crossmember.
4. Tighten the transmission cushion rubber mounting nut.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103.3 ft-lb)
T3: 35 N·m (3.6 kgf-m, 25.8 ft-lb)
5. Remove the transmission jack.
6. Install the center exhaust cover.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
7. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION">
8. Lower the vehicle.
9. Connect the battery ground terminal.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loos ...
General diagnostic table Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General Diagnostic TableINSPECTION1. MANUAL TRANSMISSIONSymptomsPossible causeCorrective action1. Gears are difficult to intermesh.NOTE:The cause for dif ...
Other materials:
USB memory
Audio files on the USB memory can be
played.
WARNING
Do not operate the player's controls
or connect the USB memory while
driving. Doing so may result in
losing control of your vehicle and
cause an accident or serious injury.
CAUTION
Do not leave your USB memory
in the car. In particul ...
Dtc p2764 torque converter clutch pressure control solenoid control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2764 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:No lock-up occurs.CAUTION:Use the check ...
Specification
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > General DescriptionSPECIFICATION1. HEATER SYSTEMItemSpecificationsConditionHeating capacity5.0 kW (4,299 kcal/h, 17,059 BTU/h) or more• Air flow control dial or switch: FOOT• Temperature control dial: HI (MAX HOT)• Temperature differenc ...
