Subaru Crosstrek Service Manual: Dtc b2a0c dcm internal fault

DIAGNOSIS START CONDITION:

When ignition switch is ON.

DTC DETECTING CONDITION:

• Main microcomputer and communication circuit IC cannot communicate. (Defective IPC)

• SIM (communication chip) cannot be read. (Defective SIM)

• Telematics function cannot be used.

• RED LED illuminates.

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A0C displayed? (Current malfunction)

Replace the DCM. Data Communication Module">

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2a0b green led circuit

Dtc b2a0d airbag signal

Other materials:

Dtc b1817 short in passenger s airbag dual stage - 2nd step (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1817 SHORT IN PASSENGER’S AIRBAG DUAL STAGE - 2ND STEP (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Airbag m ...

Parking in cold weather
WARNING Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle if you park the vehicle in snow with the engine running. CAUTION Do not use the parking brake when parking for long periods in cold weather since it could free ...

Instrument panel
Illumination brightness control Vehicle Dynamics Control OFF switch Combination meter Information display (page 3-32)/Multi function display Hazard warning flasher switch (models with multi function display) Hazard warning flasher switch (models without multi function display) ...