Subaru Crosstrek Service Manual: Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Telematics» and then select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to the List of Diagnostic Trouble Codes (DTC). Diagnostic Code(s) Display > LIST">

List

Diagnostic procedure with diagnostic trouble code (dtc)

Other materials:

General diagnostic table Inspection
DIFFERENTIALS > General Diagnostic TableINSPECTIONSymptom or troublePossible causeRemedy1. Oil leakage(1) Worn, scratched, or incorrectly seated front or side oil seal. Scored, battered or excessively worn sliding surface of companion flange.Repair or replace.(2) Clogged or damaged air breather c ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive PlateINSTALLATION1. Temporarily install the drive plate and reinforcement drive plate.NOTE:Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.2. Set the ST.ST 498497300CRA ...

Dtc b2a01 tel1 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A01 TEL1 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the followings continues for 5 seconds or more.• TEL1 impedance is more than 1 M?. (Deta ...