Subaru Crosstrek Service Manual: Clear memory mode Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. COMBINATION METER
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Combination Meter» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
2. MFD
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Multi-function Display», and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing custome ...
Control module i/o signal Electrical specification
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Combination meterTerminal No.ContentTerminal No.Content1Security indicator27Ambient sensor2Charg ...
Other materials:
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor PlateREMOVALThe crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate > REMOVAL"& ...
Removal
WIPER AND WASHER SYSTEMS > Front Wiper Motor and LinkREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">3. Remove the cowl panel assembly. Cowl Panel > REMOVAL">CAUTION:Before removin ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Parking PawlINSTALLATION1. Set the range select lever to the “N” range.2. Install the parking pawl shaft, return spring and parking pawl.NOTE:Make sure that the end of return spring sticks out of parking pawl as shown in (a). Make sure that ...
