Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Parking Pawl
INSTALLATION
1. Set the range select lever to the “N” range.
2. Install the parking pawl shaft, return spring and parking pawl.
NOTE:
Make sure that the end of return spring sticks out of parking pawl as shown in (a). Make sure that the other end contacts the rib of transmission case as shown in (b).
(A) | Parking pawl shaft |
(B) | Return spring |
(C) | Parking pawl |
3. Install the extension case. Extension Case > INSTALLATION">
4. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Parking PawlREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Shift the range select ...
Other materials:
Removal
LIGHTING SYSTEM > Rear Height SensorREMOVALCAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and remove the left rear wheel.3. Remove the sensor ...
Illumination brightness control
The illumination brightness of the instrument
panel dims under the following
conditions.
when the light switch is in the "
" or
" " position
You can also adjust the illumination brightness
for better visibility in the following
ways.
To brighten, turn the control dial upward.
...
Contrast setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or ""
switch to
select the "Contrast" item. Then push the
button.
3. Select a contrast level by operating the
"
"
or "
" switch, and confirm the setting
b ...
