Subaru Crosstrek Service Manual: Check list for interview Check

Subaru Crosstrek Service Manual / Instrumentation/driver info (diagnostics) / Check list for interview Check

INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for Interview

CHECK

• Inspect the following items regarding the vehicle’s state.

• Print out this page for interviewing customers.

Combination Meter / MFD Check List for Interview Date the Vehicle is Received Year Month Day
Customer’s name		Registration No.	Initial year of registration Year Month Date
		Vehicle model	Frame number
Interviewer	Inspector	Engine type	Odometer reading
Customer specified content • • •
Date and time when the trouble occurred		Frequency of trouble occurrence	Always occurs Sometimes occurs ( times per day, times per month)
Condition of trouble occurrence (How the trouble occurs)		Weather	Fine • Cloudy • Rainy • Snowy • Others ( )
		Temperature	°C (°F) — °C (°F)
Road conditions		Occurrence location
Accessory installation condition
Confirmation of trouble condition
Combination meter


MFD


Diagnostic code

Basic diagnostic procedure Procedure

INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURE1. COMBINATION METERSTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer th ...

Clear memory mode Operation

INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Clear Memory ModeOPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle ...

Other materials:

Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...

EyeSight (models with EyeSight system)
NOTE For models with the EyeSight system, refer to the Owner's Manual supplement for the EyeSight system. BSD/RCTA (if equipped) After entering the "BSD/RCTA" menu, select the "Warning Volume" menu. You can set the volume of the warning buzzer for RCTA (Rear Cross Traffic Alert). You can se ...

Bypass screen setting
1. Perform the preparation steps according to "Preparation for screen settings" 2. Operate the " " or " " switch to select the "Bypass Screen" item. Then push the button. 3. Select the item to set by operating the " " or " " switches. Then push the button ...