Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Preparation tool

BODY CONTROL SYSTEM (DIAGNOSTICS) > General Description

PREPARATION TOOL

1. SPECIAL TOOL

ILLUSTRATION

TOOL NUMBER

DESCRIPTION

REMARKS

SUBARU SELECT MONITOR 4

Used for setting of each function and troubleshooting for electrical system.

NOTE:

For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.

2. GENERAL TOOL

TOOL NAME

REMARKS

Circuit tester

Used for measuring resistance, voltage and current.

DST-i

Used together with Subaru Select Monitor 4.

Caution
BODY CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMAirbag system wiring harness is routed near the body integrated unit and body control circuits.CAUTION:• Do n ...

Inspection
BODY CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing diagnosis, check the following items which might affect body control system problems.1. Check the battery. Batter ...

Other materials:

Dtc p050b cold start ignition timing performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050B COLD START IGNITION TIMING PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P050A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P050A COLD START IDLE CONTROL SYSTEM PERFORM ...

Switches and harness
Inspection Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 14 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...

© 2016-2023 Copyright www.sucross.com