Subaru Crosstrek Owners Manual: Turn off display of driving information display
The driving information display can be turned off.
To turn off the display, turn the ignition switch to the "LOCK"/"OFF" position and press the "+" button adjacent to the clock display for approximately 5 seconds.
Then, the driving information display and the clock display will blink for 3 seconds to notify you that the driving information display has been turned off.
To restore the driving information display, once again press the "+" button for approximately 5 seconds.
NOTE
- The initial display setting of the driving information display has been set to operational at the time of shipment from the factory.
- The average fuel consumption and average vehicle speed are calculated even while the driving information display is not displayed.
- Even if you turn off the driving information display, the display will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.
Average vehicle speed
U.S.-spec. models
Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
Trip knob
Pressing the trip knob toggles the displa ...
Clock
To adjust the time shown by the clock,
press the "+" button or "−" button. If you
press the "+" button, the indicated time will
change in one-minute increments. If you
press the "− ...
Other materials:
Control screen and audio panel
Select to display the audio source
selection screen.
Select to change the band.
The HD Radio indicator on the top
right of the screen changes according
to the reception condition of HD
Radio (if equipped).
Select to display a station list (if
equipped). Refer to "Selecting a
...
Front passenger's SRS frontal airbag
The front passenger's SRS frontal airbag
uses a dual stage inflator. The inflator
operates in different ways depending on
the severity of impact.
The occupant detection system sensor is
installed under the seat upholstery and
monitors the physique and posture of the
front passenger. Using t ...
Dtc c1341 rl hold valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1341 RL HOLD VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 NORMAL C ...
