Subaru Crosstrek Service Manual: Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
ADJUSTMENT
1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
Reverse shifter lever | ||
Part No. | Mark | Contents |
32820AA070 | 7 | Far from case wall |
32820AA080 | 8 | Standard |
32820AA090 | 9 | Closer to case wall |
2. Select the appropriate adjusting washer from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
Adjusting washer | |
Part No. | Thickness mm (in) |
803020151 | 0.4 (0.016) |
803020152 | 1.1 (0.043) |
803020153 | 1.5 (0.059) |
803020154 | 1.9 (0.075) |
803020155 | 2.3 (0.091) |
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the b ...
Other materials:
Dtc u0428 invalid data received from steering angle sensor module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0428 INVALID DATA RECEIVED FROM STEERING ANGLE SENSOR MODULEDTC DETECTING CONDITION:Defective data was transmitted from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHE ...
If you park your vehicle in case of an emergency
Models with multi function display
Models without multi function display
The hazard warning flasher should be
used in day or night to warn other drivers
when you have to park your vehicle under
emergency conditions.
Avoid stopping on the road. It is best to
safely pull off the roa ...
Caution
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > General DescriptionCAUTION1. SUPPLEMENTAL RESTRAINT SYSTEM “AIRBAG”Airbag system wiring harness is routed near the ABS wheel speed sensor and VDCCM&H/U.CAUTION:• Do not use electrical test equipment on wiring harness and connect ...
